OPS Serial Number OSOPSI711L7xxxxx

Overview

This guide provides step by step instructions for installing customized image into the OPS.

Tools

Hardware Tools

• USB Drive (16GB or greater)
• Keyboard

Software Tools 

• RUFUS (Link)
• Win PE iso (Link) 
• Windows Image file (Link)

Process

1. Download Windows image file, WinPE ISO and RUFUS software from above links available in tools heading
2. Plug the USB drive into your laptop and create a bootable USB using RUFUS by following steps as shown in image below. Select the WinPE.iso in the boot selection option and click on Start
   
   
   
3. After making bootable USB, copy the Windows image file (named: finalImage.wim) to the same USB drive
4. Remove the USB drive from PC and plug it in the OPS
5. Turn on the OPS while repeatedly pressing the delete key on the keyboard
6. Inside the BIOS, go to Save & Exit tab and select your USB drive from the Boot Override section. Then click on Save Changes and Reset
   
    
7. You will get a Window as shown below. Here click on Apply image
   
    
8. You will get following Window. Select Windows image file (named: finalImage.wim) from USB drive by clicking on Browse button and select Disk0 in the Disk option. Also uncheck the Restart PC after applying image option. Click on Apply Image button
   
   
   
9. It will take approximately 15 mins to install the customized OneScreen Windows image
10. During installation, you might get two prompts as shown below. Just click OK and the Windows installation will be complete
    
    
    
11. After the installation is complete, remove the USB drive and click on Exit & Reboot to restart the OPS