T7 Firmware Update Guide (Power Button Method)

OneScreen T7 Firmware Installation Guide (Through Power Button)

 Overview

 This guide provides step-by-step instructions for updating the firmware on OneScreen T7 device via

 USB drive method.

 Requirements

1.  Ensure that you have downloaded the firmware files. If you haven’t or facing any difficulties, contact   our support team at support@onescreensolutions.com)
2.  USB drive (Should be a maximumof32GB)

 Process

 To install/upgrade the firmware on OneScreen T7, ensure the following:

1. Connect the USB to your PC. Right-click on the drive name in the Device and Drives section and click on Format. Then apply the settings shown in the picture below and press the ‘Start’ button to format your USB using exFAT

2.  Extract (Unzip) the firmware folder. If you don’t get an option to unzip the firmware files in your               computer, you can download WinRaR or WinZip software to extract the files

3. After the extraction process is complete, copy the extracted folder (only upgrade-3588 folder) to              the USB that you have formatted in the Step-1

4. Make sure that you don’t copy any other files on the USB after it has been formatted other than the          upgrade-3588 folder mentioned in Step 3

5. Plug the USB in USB3.0 port at the back of the Panel

6. Shut down the device by holding the power button for 3 seconds (until the power button light turns          red). Then release the power button

7. Again keep the power button pressed down until T7 boots into the upgrade screen 

8. You can release the power button once the device starts upgrading the firmware

9. The firmware update may take up to 10 mins. The OneScreen will turn on automatically once the Firmware update is complete